Johan Gustafsson
- Total activity 23
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 6
Activity overview
Latest activity by Johan Gustafsson-
Johan Gustafsson commented,
Thanks, I replied there, good that a solution will eventually come! Best, Johan
-
Johan Gustafsson commented,
Ok, thanks, looking forward to it! I can work in the old MATLAB version until then! Best, Johan
-
Johan Gustafsson commented,
Hi Jaromil, Great, I changed the IntTol to 10^-7, which I after some consideration think should be ok for my problem, and the problem no longer appeared! Thanks for the help, from my point of vie...
-
Johan Gustafsson created a post,
Can someone try to generate new mex files for the matlab interface, it may fix some issues
AnsweredHi, I have been involved in a previous thread (https://support.gurobi.com/hc/en-us/community/posts/6918802950161-Cannot-display-log-in-Matlab-macos-) where there was an issue with that the printout...
-
Johan Gustafsson commented,
Hi Jaromil, Thanks, looking forward to see what you will conclude! Best, Johan
-
Johan Gustafsson commented,
Correction: The other parameters seem to matter as well. If I skip setting the IntFeasTol, it goes fine. However, if I only set the IntFeasTol, it also goes fine. With the combination, it doesn't.
-
Johan Gustafsson commented,
Ok, I understand now why you cannot reproduce it - you are using different parameters. Run the following code, this should reproduce the problem: prob102 = gurobi_read(['c:/Code/ExpModelv10_0.mps'...
-
Johan Gustafsson commented,
Ok, thanks for looking into this. I will debug this more and see if I can figure out more details about what has happened!
-
Johan Gustafsson commented,
Hi and thanks for the quick reply, the file is here:https://drive.google.com/file/d/1uY99lSKOLYg_EEX_H1JVv6V3gClKQOkL/view?usp=share_link Best, Johan
-
Johan Gustafsson created a post,
Gurobi v. 9.5.2 and v.10 gives different results for the same small problem
AnsweredHi, I have just upgraded to Gurobi v. 10, which lead to that my previously built algorithm (based on a MILP) no longer works in some cases. I debugged it thoroughly, and it seems that v. 10 of Guro...