How to execute for-loop iterations in parallels in MATLAB using Gurobi as a solver?

Answered

Nazanin Madani

June 24, 2020 02:54

• 
• 
• 

Hello,

I have a MIP problem, which I decomposed into subproblems, and I want to solve these subproblems using Gurobi in MATLAB. The only thing that changes in each subproblem is the objective function, and all the constraints are the same for all the subproblems.

When I try the "parfor," I get an error that it can not run due to the way variable "modela" used (I attached the loop). Can anyone help me with it?

Thanks

0

• Official comment

  

  Simranjit Kaur

  • Gurobi Staff

  December 06, 2024 00:44

  This post is more than three years old. Some information may not be up to date. For current information, please check the Gurobi Documentation or Knowledge Base. If you need more help, please create a new post in the community forum. Or why not try our AI Gurobot?.
• 

  Jaromił Najman

  • Gurobi Staff

  September 07, 2020 13:54

  Hi,

  It should read \(\texttt{modelsense}\) instead of \(\texttt{modelsence}\).

  Best regards,
  Jaromił

  0

Post is closed for comments.