Inconsistent result when putting gurobi inside the loop
AnsweredI put Gurobi inside a loop where in each iteration the values of the constraints change within a range of ±5%, but the optimization results are very different, and there are even results showing 0, whereas logically 0 is impossible. Is there anything that can help me with the issue I'm experiencing? Thank you
-
Official comment
-
Gurobi Staff
This post is more than two years old. Some information may not be up to date. For current information, please check the Gurobi Documentation or Knowledge Base. If you need more help, please create a new post in the community forum, or try Gurobot, our chatbot interface offering instant, expert-level support. -
-
-
Please take a look at our article: How do I diagnose a wrong result?
-1 -
-
Additionally, perhaps this is a snippet of the optimization results where the list for each node to node is the mass rate resulting from the Gurobi optimization placed within a loop of more than 1000 iterations, where it can be seen that there are results that are 0 and there are quite a few of them.
0 -
-
Thank you so much for the response, Simranjit Kaur
0 -
Post is closed for comments.
Comments
4 comments