set an initial value for a variable in Gurobi
回答済みHello everyone, I have encountered a perplexing problem when setting initial values using Gurobi. For example, if I want to set the initial value of a variable "var" to -10000.
And I manually checked that this initial value satisfies the constraints. However, Gurobi also reported during runtime that it successfully used the initial value I provided to solve the model: "User MIP start produced solution with objective 0 (0.02s) Loaded user MIP start with objective 0".
However, when I checked the values of the output variables that Gurobi successfully solved again, I found that the value had changed and was no longer -10000 that I provided, but became 0. However, when I checked the start property of the variable, it was still -10000, which confused me a lot. Can you help me with this?

-
正式なコメント
This post is more than two years old. Some information may not be up to date. For current information, please check the Gurobi Documentation or Knowledge Base. If you need more help, please create a new post in the community forum, or try Gurobot, our chatbot interface offering instant, expert-level support. -
Hej,
By default the lower bound and upper bound for the variables is 0 and + infinity that is set by gurobi unless you specify otherwise. I think its the reason that when you optimize and check again it takes the lowest value which in your case would be 0 same as the lower bound.
If you use this, then it will take values in negative as well
m.addVar(var, lb=-gp.GRB-INFINITY, vtype=___)
or
m.addVar(var, lb=-10000, vtype=___)3 -
Thanks!!! I checked my code and indeed found the issue. Thank you very much for your help!
2
投稿コメントは受け付けていません。
コメント
3件のコメント