メインコンテンツへスキップ

Objective value convergence and sub-optimal termination

回答済み

コメント

3件のコメント

  • 正式なコメント
    Simranjit Kaur
    • Gurobi Staff
    This post is more than two years old. Some information may not be up to date. For current information, please check the Gurobi Documentation or Knowledge Base. If you need more help, please create a new post in the community forum, or try Gurobot, our chatbot interface offering instant, expert-level support.
  • Maliheh Aramon
    • Gurobi Staff

    Hi,

    You might want to try the following parameters too:

    Refer to the Presolve section in the numerical guidelines for more details on how presolve can exacerbate numerical issues.

    Experimenting with different values of the BarOrder parameter is also worth trying.

    Given that your model has 32M nonzeros, the simplex algorithm might be slower than the barrier method, but it could help with numerics.

    Check the section "Making the algorithms less sensitive" in the numerical guidelines for parameters that can help different types of optimization models with numerical challenges.

    Best regards,

    Maliheh

    0
  • Philipp Dunkel
    • Gurobi-versary
    • First Comment
    • First Question

    Dear Maliheh,

    thank you very much for your suggestions.

    I tried using the ScaleFlag parameter with different values first and had great success with it! With this set to 1 none of my runs had any of described issues anymore.

    Nevertheless, I will also try your other suggestions.

    Thank you,

    Philipp

    0

投稿コメントは受け付けていません。