UnicodeDecodeError when i debug the programm with Gurobi

回答済み

jiahui Duan

2020年12月13日 11:31

• 
• 
• 

After installing the Gurobi ans gurobipy package, when i debug the program, it raise an error which is shown as follows:

Traceback (most recent call last):
File "extern.pxi", line 19, in gurobipy.__bytestostring
UnicodeDecodeError: 'utf-8' codec can't decode byte 0xb6 in position 28: invalid start byte

however, when i directly run the program, it can output the result (although the error is raised). when debugging, programm cannot run. The error happens when i run the 'model = Model()'.

0

• 正式なコメント

  

  Simranjit Kaur

  • Gurobi Staff

  2025年06月23日 03:03 編集済み

  This post is more than three years old. Some information may not be up to date. For current information, please check the Gurobi Documentation or Knowledge Base. If you need more help, please create a new post in the community forum. Or why not try our AI Gurobot?.
• 

  Jaromił Najman

  • Gurobi Staff

  2020年12月14日 09:15

  Hi Jiahui,

  The error you see is usually raised when one tries to encode a non-ascii character. Could you post a minimal working example of the code producing the error?

  
  Best regards,
  Jaromił

  0
• 

  jiahui Duan

  2020年12月15日 12:11

  • 
  • 
  • 

  Hi,Jaromił:

  Thanks for your reply. I have addressed this issue. I found the path of conda and Gurobi contain some Chinese character, which cause the error in program. Changing it to english makes sense.

  Best regards!

  Jiahui Duan

  0

投稿コメントは受け付けていません。