Skip to main content

How can I disable Crossover in my specific case

Answered

Comments

3 comments

  • Official comment
    Simranjit Kaur
    • Gurobi Staff
    This post is more than two years old. Some information may not be up to date. For current information, please check the Gurobi Documentation or Knowledge Base. If you need more help, please create a new post in the community forum, or try Gurobot, our chatbot interface offering instant, expert-level support.
  • Eli Towle
    • Gurobi Staff

    Note that you would set the Crossover parameter to 0 (not 1) to disable crossover.

    According to the GBOML documentation, you can add Gurobi parameters to a file named \(\texttt{gurobi.opt}\) (this is referenced in your screenshot), then pass that file to the GBOML command-line interface via \(\texttt{--opt gurobi.opt}\). In your case, the \(\texttt{gurobi.opt}\) file would contain the single line

    Crossover 0
    0
  • Houssem Eddine KAFI
    • Gurobi-versary
    • First Comment
    • First Question

    Thank you Eli Towle ! It works just fine ! 

    0

Post is closed for comments.